List of Instructions
Catalog
(shopping cart enabled)
Earth Guild Home

PRE-REDUCED INDIGO INSTRUCTIONS

THESE INSTRUCTIONS ARE FROM THE JACQUARD PAINTS WEB-SITE
This specially formulated indigo is already 60% reduced, making it possible to use Washing Soda instead of lye in the dye vat. And the pre-reduced indigo granules dissolve very easily in water.

Precautions: Please use an organic fume respirator when working with the Sodium Hydrosulfite. Do not use utensils or dishes used for eating. Wear gloves.

The following recipe fits well in a 5 gallon bucket:

• 50 grams Pre-reduced Indigo
• 150 grams Sodium Hydrosulfite
• 250 grams Soda Ash
• 15,000 ml water:

Make a vat with cool tap water, about 60 to 70° Fahrenheit. A straight-sided container with a tight fitting lid works the best. Add the indigo and the Sodium Hydrosulfite to the vat and stir.

Try to dissolve the Soda Ash by adding a little boiling water to it. It won’t completely dissolve. Add the soda ash to the vat. With a dowel or stirring stick, stir in a circle, going in one direction. Slow down and reverse the direction of the stirring, dragging your stick along the outer edge of the vat before removing it. This will bring the foam that has formed, which is called the “flower”, to the center. Let the mixture settle (at least a few hours for the 5-gallon vat and longer for bigger vats). The liquid should be a clear yellowish-green color.

When you are ready to dye, wet your fabric and squeeze out any excess water. Skim the “flower” and crust off the top of the vat and set aside. Enter your wetted-out fabric slowly and manipulate under the surface of the water. You don’t want to stir up the sediment at the bottom of the vat. Squeeze the fabric as you lift it out trying not to drip or make bubbles, as this introduces more oxygen into the vat. When you lift your fabric out, it will be a yellow-green color. As the air hits the fabric, the indigo will gradually oxidize and the fabric will turn blue. After 15 to 20 minutes, you can re-dip your fabric for darker shades, or rinse and un-tie (if doing tie-dye) and wash.

When you are finished dyeing, put back the “flower” and stir the vat in the same circular manner as described above. Put a lid on the vat and it will be ready for another dye session when all the sediment has settled back to the bottom. The indigo vat can last for several weeks or months if properly tended.

Tending an Indigo Vat:

An indigo vat can have a very long life if used and tended to regularly. As mentioned above, the best type of container for a vat is a cylinder shape with a tight fitting lid. This will give you room to dye the fabric without it touching the bottom and minimize the surface area that is in contact with air. Occasionally, you may need to add more of the reducing chemicals and the pre-reduced indigo to keep the vat going. Always try to dissolve the Soda Ash in a little water before adding to the vat. Start by adding a little at a time. Sometimes more than one addition is needed. When you add something to the vat, it is important to wait for the chemical reaction to take place (at least 1 hour) before adding more.

• If the vat looks more blue-green than yellow-green, or if you see blue particles suspended in the liquid, the vat needs to be reduced more. Add 2 to 10 grams of Sodium Hydrosulfite at a time.
• If the color seems weak, or the liquid in the vat is gray and watery, an addition of the pre-reduced indigo is needed. Add 2 to 10 grams at a time.